ESD floor polish
A floor polish that leaves a warm gloss and a protective layer. Fortified with Avetran for ESD performance, approved by independent laboratories.
Benefits
Floor protection
Protects the floor from traffic wear and makes cleaning easier.
Static
Reduces electric shocks and the equipment damage they cause. Meets the basic requirements of IEC 61340-5-1.
Slip
Slip resistant to ASTM D-2047.
How to use
Use only on floors that have been stripped, rinsed thoroughly, and are completely dry. Pour sparingly and spread while still wet with a polish applicator, in overlapping lanes about 1–1.5 m wide. Always apply 3 coats, with at least 60 minutes of drying between coats. After the last coat, wait at least 60 minutes before traffic. Recoat every 3 months in busier areas and every 6 months in quieter ones. Ready to use. Do not dilute.
Let a new treatment cure for 48 hours before any wet maintenance. Remove loose dirt daily with a dry mop. Maintain dissipation with TASKI Jontec Destat: 3 times a week in heavier traffic, once a week or as needed in light traffic. Do not rinse after application. In dry rooms, apply 3 times a week to keep readings low.
Technical data
- Appearance
- Milky white liquid
- pH, neat
- About 8.9
- pH, in use
- About 8.9
- Relative density, 20°C
- 1.029 g/cm3
- Pack
- 2 × 5 L
| Appearance | Milky white liquid |
|---|---|
| pH, neat | About 8.9 |
| pH, in use | About 8.9 |
| Relative density, 20°C | 1.029 g/cm3 |
| Pack | 2 × 5 L |
Figures are typical of normal production and are not a specification.
Contact
If you have a question or would like to talk, please get in touch.