Other
Factory Environment Solutions
TASKI Jontec ESD
Static dissipative floor emulsion
Static dissipative floor emulsion specially developed to dissipate electric charges over the surface of any type of floor or let to ground on conductive floors.
It builds a warm, high gloss protective film which responds to a wide range of maintenance techniques.
Ideal solution for areas where you face a static dissipative issue and for ESD approved floors to help ease cleaning and maintain a good appearance.
Delivers a warm gloss, protective layer
Fortified with AvetranTM to ensure ESD capabilities
ESD approved by independent laboratories
Slip resistant according to international standards(ASTMD-2047)
Benefits
Protects your floor investment against traffic abuses and eases cleaning
Eliminates risk of electric shocks and therefore of damages of equipments
Fulfills basic requirents of IEC 61340-5-1
Guarantees safety for your employees, patients and customers
Usage instructions
Treat only stripped and thoroughly rinsed and completely dry floors. Sparingly pour the product onto the floor and evenly spread it while still wet with a polish applicator in overlapping lanes of 1 - 1.5 m.
Always apply 3 coats on the floor and always allow a 60 minutes minimum drying time in between two coats. After the last coat, allow minimum 60 minutes before traffic.
To keep static dissipative capability and high gloss, recoat in medium to high traffic areas every 3 months and in low traffic areas every 6 months.
Dosage:
Ready to use, no dilution required.
Maintenance:
Always allow a new treatment to cure for 48 hours before doing any type of wet maintenance.
Remove loose dirt with a dry mop on a daily base.
To ensure static dissipative capability, maintain with TASKI Jontec Destat.
Apply TASKI Jontec Destat 3 times a week for moderate to heavy traffic areas. Apply once a week or as needed on light traffic areas. Do not rinse the floor after application.
In dry environments, apply 3 times a week to keep static dissipative readings low.
Technical data
Appearance | Milky, white liquid |
pH value (neat): | ≈ 8.9 |
pH value (in use): | ≈ 8.9 |
Relative density (20°C): | 1.029 g/cm3 |
The above data is typical of normal production and should not be taken as a specification.
Available pack sizes
